![]() ![]() If you like DIY’s similar to these, you will LOVE these others!Īnd if you like what you see, join our DIY community to access freebies only available for subscribers! You will receive a monthly newsletter with a summary of new projects.Decorative Wall Hook Rack : Target Target / Home / decorative wall hook rack (307) 307 results Sort by Relevance 27" Hook Rack with Flared Tri-Hooks - White/Satin Nickel - Threshold™ Threshold Only at ¬ 68 $32.00 Assembly starting at $50 at /Assembly Free 2-day shipping Not at your store Check nearby stores Add for shippingSKÅDIS pegboards offer accessible, playful and flexible storage. I love comments! □Īnd don’t forget to Pin this for the future and to share with your DIY friends! What do you think? Tell me in the comments. I think my next one will have hinge clips and chalkboard paint. I hope you like this and give it a try! Think of the possibilities. You can use nails or even command strip hooks to hang it on the wall, like I did for this one, since I knew I was giving it away. To hang on the wall, I attached D ring hangers to the back of the piece. Good grief, could they be any cuter? You should see the ones I used for my bathroom vanity, and my entry way shiplap wall. They are all so gorgeous. I am also utterly addicted to Hobby Lobby’s knobs and pulls. What can I say, I trip easily and compressors scare me. You’re there! Attaching the hooks is pretty easy with this awesome cordless drill. I used 3/4″ wood screws. Once the stain was dry I glued them to the back piece and reinforced with my cordless nail gun. I left barn wood pieces pieces raw because they are beautiful just the way they are. Then I gave them a coat of dark walnut stain. Make sure the 90 degree angle is facing out.Īt this point I sandedand stained only the top trim piece and the basket. ![]() Glue the pie slices to the front piece, flush with the top. Side note: These make great door stoppers if you want to cut a few more. ![]() You now have two equal pieces for the sides. Then make the cut, as shown below.Ĭongratulations. ![]() Here’s a tip for the second piece: Turn the board over so the bottom side you see above faces up (as shown below). Once you make the cut, you should end up with a piece like the one below. Notice the blade is set down as far to the right as possible while still hitting the bottom edge of the board. Set your 1×10 piece on the saw and set the miter angle at 15 degrees (move the miter adjustor to the right until it points to 15 as shown below). But, If you want the slanted look, read on. If you don’t have a miter saw you could make square cuts to size for the sides and bottom. The side pieces that hold the basket came from a scrap piece of 1 x 10 mitered at 15 degrees. Let it sit for a while (at least 20-30 minutes).ĭo the same thing with the short pieces. To assemble the back, simply apply wood Glueto the sides and clamptogether. Plus, did I mention they were speaking to me? Wood and I are tight. They’re a little more money, but I decided they would give this piece the farmhouse look I was looking for, so I splurged.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |